Sc67310 Ricoh Error | Extra Quality |work|

The panel was not shut down correctly, causing a glitch in the software.

Unplug the power cord from the wall outlet and wait at least .

Turn off the primary power switch located on the side or back of the machine. Unplug the power cord entirely from the wall outlet. sc67310 ricoh error extra quality

Keep the equipment in a climate-controlled room. Excessive humidity can corrode delicate ribbon cable contacts, while extreme dryness increases static discharge risks.

The main board controlling the printing functions is failing. The panel was not shut down correctly, causing

To clear persistent SC codes, enter the Service Program (SP) mode. On many models, this is done by pressing [Clear Modes] , then [0][7] , and holding [Stop] until the screen changes. Navigate to System SP > 5810 (SC Reset) and restart the machine.

Here’s a clear explanation and solution path: Unplug the power cord entirely from the wall outlet

If the hard reset fails, the system may have turned off its communication interface protocol. You must access Ricoh's internal Service Mode to fix it.

The most frequent culprit behind a sudden SC673-10 fault is an unconfigured or deactivated Service Program (SP) parameter.

Turn off the power and unplug the machine. Use an anti-static wrist strap.