Ensure the control unit is pushed into the furnace base until the locking bolts engage with an audible click.
What specific (e.g., Er01, Er23) is showing on the screen? ivoclar programat p90 manual fixed
: Check that the vacuum hose is securely connected and that the firing chamber seal is tight. Ensure the control unit is pushed into the
: The main power switch (0/I) with a green pilot lamp is located on the furnace. Upon switching on, the furnace typically heats to a standby temperature (B) : The main power switch (0/I) with a
If your furnace fails to reach the required mercury or millibar vacuum level during a firing cycle, your ceramics will appear milky or under-fired.
: Do not clean the firing muffle with compressed air lines. The internal insulation consists of high-temp ceramic fibers. Airborne fiber dust can pose severe respiratory hazards if distributed throughout the lab room.
: Run a cycle targeted to reach the melting point of silver ( 961∘C961 raised to the composed with power C