Water Softener Installation Manual | Harvey Hv3

Before turning the water back on, double-check that all connections are tight and properly aligned. Pay special attention to the orientation of the bypass valve—it should be in the open position initially.

Never run the drain or overflow hoses upward by more than 1 metre above the base of the machine. 🚀 Commissioning and First-Time Start-Up

Softened water will have no adverse effect on a septic tank if the system is functioning correctly. The regeneration discharge is safe for typical waste treatment systems. harvey hv3 water softener installation manual

: Insert a flat-blade screwdriver into the white button under the cover. Press and rotate one full turn clockwise until it pops back up. The unit will drain for roughly 10–12 minutes.

Here are a few tips and considerations to keep in mind when installing the Harvey HV3 water softener: Before turning the water back on, double-check that

: Fit a three-valve bypass manifold (Inlet, Outlet, and Bypass valves) into the main water line. Connect Hoses : Remove red plastic caps from the unit's ports.

The drain line carries away the brine and backwash water during regeneration. The manual specifies: Press and rotate one full turn clockwise until

Some later HV3 models have a 12-day override dial. This forces regeneration if the water meter hasn’t tripped it. Set it to maximum (12 days) initially.