Delphiautocom Cdp 2017r3 On Win10 Mhh Auto Page 1 Work [exclusive] Page

Below is everything you need to successfully install, activate, and configure your Delphi/Autocom CDP 2017.R3 clone or original interface on a modern Windows 10 environment. 📋 System Requirements & Technical Preparations

According to multiple MHH Auto documentation sources, the delivers the following capabilities:

A successful installation relies entirely on this preparatory phase.

[CDP+ Device] ---> (USB Cable) ---> [Windows 10 PC] ---> (Select COM Port) ---> [Test & Update Firmware] Hardware Setup Steps Launch the Delphi/Autocom software. Go to the top menu and select > Hardware Setup . Choose Diagnostic Tester (CDP+/Autocom) . delphiautocom cdp 2017r3 on win10 mhh auto page 1 work

Enable .NET Framework 3.5 via "Turn Windows features on or off". Windows 10 blocking unsigned clone drivers.

Restore the patch file from quarantine, disable Defender, and re-run the patch. 3. Slow Communication with Vehicles

Note the exact COM Port number assigned to your device in the Windows Device Manager (e.g., COM3 ). Below is everything you need to successfully install,

Select the button to verify the connection between the PC and the VCI.

:

If the software fails to launch or "Page 1" hangs, check the following: Go to the top menu and select > Hardware Setup

Right-click Main.exe , go to Properties, and set Compatibility Mode to "Windows 7."

To make the “Page 1” fix permanent, MHH member “cdp_power” suggests this registry edit: